One of my friends was celebrating his birthday and wanted support for his trip to the Maldives. As I didn't want to simply give money in an envelope, I searched the 3D printing platforms for content about the Maldives and found what I was looking for here. Thanks to https://www.printables.com/@hassage_290746for his low-poly model. I scaled it to a length of 138.5 mm, adjusted the XY hole and contour compensation as well as the slice gap closing radius in the slicer a little and had the model that was criticized by the slicer (Bambu Studio) repaired and received a model of a Dhoni that could be printed without any problems. In addition, I modeled a mast and boom for the boat so that I could use a folded banknote (75 x 90 mm) as a sail. The gift of money was finished and I published the remix in compliance with the specified CC license on https://makerworld.com/en/models/1113331#profileId-1110287(edited)
One of my friends was celebrating his birthday and wanted support for his trip to the Maldives. As I didn't want to simply give money in an envelope, I searched the 3D printing platforms for content about the Maldives and found what I was looking for here. Thanks to https://www.printables.com/@hassage_290746for his low-poly model. I scaled it to a length of 138.5 mm, adjusted the XY hole and contour compensation as well as the slice gap closing radius in the slicer a little and had the model that was criticized by the slicer (Bambu Studio) repaired and received a model of a Dhoni that could be printed without any problems. In addition, I modeled a mast and boom for the boat so that I could use a folded banknote (75 x 90 mm) as a sail. The gift of money was finished and I published the remix in compliance with the specified CC license on https://makerworld.com/en/models/1113331#profileId-1110287 (edited)