Works as expected
Excellent little print - easy, quick, does the job quite perfectly.
Probably very easy to scale up or down to adapt to your window as well - this appears to be intended for a 45mm window thickness (see second picture, the lowest horizontal edge is roughly 45mm long).
The design is functional and works. Printed it for my two kids and therefore marked their sides in different colors. As it is quite small (by design) let’s see how it handles the roughness of my kids
Hi. this is just what I am looking for.
Where did you source the mounting hw and is this something i could by of you?
Roughly where in the world are you located. I myself am located in Denmark.
@RuniPoulsen_963316 hey, what do you mean by mounting hardware? Screws and nuts are just from the hardware store and the metal clip is a factory part, which was installed already in the car. I guess that should also be purchasable at the dealership.
Yes it was the clip i was after :)
View one more comment
@hardwarepoint thanks for that part no. In my car (Toyota proace based on psa platform) there is only used a plastic cover over that mount. It has flimsy plastic clips holding it in place. With your part i should finally be able to mount the camera securely :)
@RuniPoulsen_963316 perfect :) I just drilled a hole into that metal clip to use a screw for the attachment to the 3d printed part. So far still attached
Nice design. Shrunk down and printed for my son to use when playing with kinetic sand.
