Hello, I printed this in PLA and the scaling was much too big. Did you have to scale yours down any?? It just falls off of the head and does not stay put. (edited)
@Teakdamar_68345 I had the same problem you did. I had to bring the top down by 6mm so the height is 13.5mm then shrink the width down to 7mm. Fits perfectly then! (edited)
I would give a much higher rating but the .stl file for the razor's head is too large and doesn't match what you have in your picture. I had to bring the top of the object down by 6mm and reduce the width by 1mm. Once I did that if fit perfectly! Attached are the adjustments I had to make in PrusaSlicer. (edited)
This modification is an absolute must!
Well done.
@19ady4_5036 Yes, you are right.