fergusnoble 6
fergusnoble
@fergusnoble_628922
published a new model June 6, 2023 at 4:09 PM
June 6, 2023 at 4:09 PM

Slightly modified for pin punches. Labeled each location. Print came out great. Used Inland HS PLA+.

This is going to be excellent for my paint brushes

Ctrl + Enter to send Enter to add a new line
fergusnoble 6
fergusnoble
@fergusnoble_628922
published a new model April 6, 2023 at 6:01 AM
April 6, 2023 at 6:01 AM

What size insert was this made for?

@Joe_856941 measuring the hole I get 6.4mm which translates to 1/4". Which I think is for a m5 screw.

What was the wall thickness you used, in particular around the springs?

Ctrl + Enter to send Enter to add a new line
fergusnoble 6
fergusnoble
@fergusnoble_628922
published a new model April 3, 2023 at 1:03 AM
April 3, 2023 at 1:03 AM

Ctrl + Enter to send Enter to add a new line
fergusnoble 6
fergusnoble
@fergusnoble_628922
published a new model March 3, 2023 at 5:55 AM
March 3, 2023 at 5:55 AM

Ctrl + Enter to send Enter to add a new line
fergusnoble 6
fergusnoble
@fergusnoble_628922
published a new model March 2, 2023 at 7:17 AM
March 2, 2023 at 7:17 AM

Ctrl + Enter to send Enter to add a new line
fergusnoble 6
fergusnoble
@fergusnoble_628922
published a new model February 28, 2023 at 10:51 PM
February 28, 2023 at 10:51 PM

Printed too fast, 400 mm/s is too much for this model, filament and printer

View one more comment

@fergusnoble_628922 Went 4 stars based on the loose fit in the drawer, I will end up generating my own similar STL for a tighter fit. Perhaps different generations have different widths?

@zekesnack Fair, on my Gen 1 toolbox the gap is about 2 mm on each side, could be a little tighter. I left some slack to clear the various tabs.

Ctrl + Enter to send Enter to add a new line
fergusnoble 6
fergusnoble
@fergusnoble_628922
published a new model February 27, 2023 at 4:56 AM
February 27, 2023 at 4:56 AM

Ctrl + Enter to send Enter to add a new line
All items loaded