Thanks Fae, this thing is incredible !

Perfect, used a vise to press the body parts on. Top part is a little looser than the rest, might reprint it with a bit smaller circle and vise press it onto the screw so it doesn't need the glue.
I just read about this on the Makera Discourd and wanted to drop you a comment. Great looks mods. I might try and make them down the road. Thanks for posting them.
I printed this model the other day, but I'm abit curious about the hole on the bottom-base, is it meant to fasten the model to the carvera?
@JNHobbymaker
The hole is for a brass pipe that fits through the center hole of some of my stepped riser blocks. Between that and the hole in the side the caddy can hold 4 stepped risers
Love it! Thanks for sharing.
I modded the STEP file to allow for 2.5mm Uxcell dowel pins instead of the Makera 2mm pins, ran out of ATC slots and had to get rid of the 2mm drill bit but kept the 2.5mm for PCB mount holes.
I also upscaled it to 102%, as the original was a tad too tight for my work holding screws.
Atomic Filament PETG silver is nearly a perfect match for the Carvera silver color.
Thanks Fae! my ABS ones were super hard to install and usually broke when I removed them. great idea!
Pedrothemagnanimous