Hey, I'd like to make a nevermore filter, but i don't know where to connect the two fans to. Could you maybe send some pictures on where and how to connect the fans?
@LorenzTeufel_2823306 Sure! What I did was connect both fans in parallel (red wire to red wire, black wire to black wire) and disconnected the exhaust fan from the motherboard, replacing it with the 2 fans inside the nevermore. make sure they are 24 volt fans! This exhaust fan isn't needed, because the filter circulates the air instead of pushing it out. I'll be sure to add a photo for reference (edited)
Model prints and fits very well. I am running into an issue were the bed cable drags on the charcoal holder and knocks it off. Any suggestions to mitigate this?
Hey, I'd like to make a nevermore filter, but i don't know where to connect the two fans to. Could you maybe send some pictures on where and how to connect the fans?
@LorenzTeufel_2823306 Sure! What I did was connect both fans in parallel (red wire to red wire, black wire to black wire) and disconnected the exhaust fan from the motherboard, replacing it with the 2 fans inside the nevermore. make sure they are 24 volt fans!
This exhaust fan isn't needed, because the filter circulates the air instead of pushing it out. I'll be sure to add a photo for reference (edited)
@eellliott_2021713 Ok, makes sense, thank you
Model prints and fits very well. I am running into an issue were the bed cable drags on the charcoal holder and knocks it off. Any suggestions to mitigate this?