As in the description, we've used a good few of these to run conduit nice and neatly.
Shame that we didn't have colour-matched filament!

As in the description, we've used a good few of these to run conduit nice and neatly.
Shame that we didn't have colour-matched filament!
I just had this issue, wanting to install a G5 Dome ultra using the compact Junction box, and I was scouring my local store to see if they had something similar. This is just what i needed!! thank you!!
Prusament PETG.
0.25mm Layer Height
0% Infill
Supports: Everywhere.
Shown with fashionable Arduino Education Lanyard (edited)
Not a perfect fit around the corners, but it's good enough that it doesn't look out of place.
Since it lacks a connection between the pieces, they're both a bit fiddly to put on (start with one pair of corners farthest away from each other, and then add the other two) and slightly prone to wanting to move off from under the Mac.
I suggest gluing a very thin piece of rubber at least under the feet, though on the lips where the Mac sits might also be a good idea, to prevent accidental slippage.
Glad you could make use of the base plate.