@nsk1max_1731654 It's a little shorter than a 40oz but I do have a takeya 40z I alternate with. I don't have a silicone sock on either of them but I'm sure you'd have to remove it for it to fit. I do acknowledge that I should run it in a less heat sensitive material but for this instance it worked for me (I need to finish a spool to make room for a new one); it held up for a solid 2 months as I usually removed it or used a sunshade (vehicle is currently a fishbowl with no tint). When the weather warmed up, the left side holder warped slightly so the bottle is a very snug fit on that side. Can probably be fixed with a little sanding; will reprint in a stronger material next go around.
Printed on inland tough pla; works as described!
@nsk1max_1731654 It's a little shorter than a 40oz but I do have a takeya 40z I alternate with. I don't have a silicone sock on either of them but I'm sure you'd have to remove it for it to fit. I do acknowledge that I should run it in a less heat sensitive material but for this instance it worked for me (I need to finish a spool to make room for a new one); it held up for a solid 2 months as I usually removed it or used a sunshade (vehicle is currently a fishbowl with no tint). When the weather warmed up, the left side holder warped slightly so the bottle is a very snug fit on that side. Can probably be fixed with a little sanding; will reprint in a stronger material next go around.
@probablynic_1733726 Thank you for sharing your feedback!