Prints very easily. Nice clear numbers. Sides are slightly sharp, could perhaps do with some fillets, which might also help it roll better, but I'm nitpicking.
In the photos, my print was oriented with the 3 face facing up.
Print was on a Prusa Mini+ with Prusament PETG, 0.25mm nozzle, 0.15mm layer height. (edited)
Works almost perfectly. The front insert grabs the magnet, causing it to come out when pulling off the stand. Was able to trim it down a bit with an X-Acto knife and it was all good.
@xBigGlazyx_836165 Glad it worked out!
For the other side, is it just a straight mirror on the slicer?
@TurBr0d3ur_1384239 Yep! Just mirror it and it will work just fine.
@strajk_453649 Awesome! I hadn't even tried stacking them, I'm glad that works too!