@biehlerjosef_1334332 Are you planning it for all sizez?
View 2 more comments
@PanLyzwa_1157804 I have seen, you made a remix. Thanks :) Let me know if it works good. I will have to redesign the holder to be able to print it not standing but laying on the heat bed. When printing it standing in the bed, the holder will break. I touched the holder a few times only slightly and it breaks. It still falls not off due to the screw. Thus I will try to print it laying on the bed to have the print layers from the mount-side to the front-side. This should be much more stable for that use case
@biehlerjosef_1334332 squares fit info it. I still didnt test it on a wall
Which mount are you using for the sensor? I used this ( https://www.thingiverse.com/thing:6354680) one, which I really quite like, but it has a higher lip than yours so this cable organizer doesn't fit well.
But You know that sensor should be mounted only for calibration, after that it is only unnecesary mass on print head. It will works only at first calibration.
Tight squeeze to get the cable in, but it fits perfectly and slides smoothly once it's in. The attachment to the rail is also tight but perfect once you get it on. And it does a perfect job keeping the cable out of the way.
@speckledmush_1633482 Hi thanks for your make. Maybe you need this one too: https://www.printables.com/de/model/823150-ender-3-v3-se-ke-nebula-sensor-cable-organisator
;-)
@biehlerjosef_1334332 shameless, but you're right! XD