Hey, thanks! Are there any step files available? I'd like to make them work for 16mm conduit
Printed with army green matte PLA and came out great. It is a bit flimsy, but I was expecting that. It uses little filament and prints fast, both of which where exactly what I was looking for.
I like the box, it's simple, but PZEM can't get into it, live wires stick out from the PCB and you can't even close the box by force.
@TomasVida_321126 thank you for the feedback, and I'm sorry it didn't work for you. I think I had to cut the wire very close to the PCB to not protrude.
Gets your brooms off the ground 👍 scaling down for smaller holes doesn't affect the strength of the print
What power supply did you use? How is it mounted?
@Blake_39160 Sorry for this long time, I just saw your comment now, I'm using 3 laptop power supply connected in series to have around 55v at 4 amps, I disconnected the ground from 2 of them to avoid short circuit, each PSU has a reverse bypass diode for protection. The PSU are zip tied together and are fixed by some spacer (edited)
@bumbobee_1265756 thank you for your feedback! I also have some other tipe-c connector, and they don't fit as well, the tipe-c male trigger I designed for is very thin, if you want you can scale it up in cura! (edited)
Yeah gota try agin
