I had some issues with the original. With this upgrade i had no issues so far. Tank you :)

With your permission, I'd like to put this on a t-shirt for myself.

Great little coin holder. Printed in black Overture PETG, since I plan to keep it in my car to feed parking meters. For hardware I used some 8mm m3 screws and some compression strings from a hardware store assortment pack.

Without 1-2 cent is a better solution, thanks. I used four m3 screw (16mm) and six 9x35mm compression strings. Printed with grey PolyMax PLA (edited)

hi, i like your dice a lot, but could you make the one side with the long thing (three blocks) instead of 3 holes with 4 holes?
This would be great.
Thanks

Perfect print