Very nice. Works without any problems.
Thank you very much!
Man! havent print it yet but you saved my life! this looks like will save my problem of tubes pulling out like crazy
@IGambitoI_1804827 did this solve your issue? I’m having the same issue where the ptfe tubes keep pulling out from the stock filament hub.
@DiegoSanchez_914869 late reply but yes
my hub's center tube is 18+mm... the STL shows 17.4mm inner diameter... at least for me it didn't fit.
@PaulKenjiCahi_837865 Nevermind actually. I did'nt understand properly the use of the hex part. It seems it is an extension/tightening device rather than a part inside
This model works beautifully, no supports are needed if you use variable layer height and set the threaded areas to as fine of a layer height as you can. I've printed 4 of these, currently only have 2 in use since most of my filament fits on the AMS as is. Thanks for making this, you are a king!