Fits very snug in the holes of the spool and pops out easily to reuse on a new spool.
Wanted something to store the pen outside of the flex keyboard, and this is perfect. Easy print, works really well. Thank you !
@saerian_501059 Nice. thanks for sharing (edited)
Here is my Make with 9 of your Parts. They are the heard of my painting hobby multiboard wall. Posted also a Foto of the current state of the wall. I thing your design looks amazing on the Wall, and I can easy read all color names =)
Thanks for sharing. I'm happy you like it. Easy to see paint labels was one of main goals when I was designing those holders. other was easy to print and to be print support free. this is the reason why i use separate brackets and pegs here.
I don't think it turned out too bad for my first print, the rails are a bit tight (definitely not getting this shelf off of them), but I believe that's an issue with my printer. I should be able to fix it next print.
@feildmaster_2597741 not too bad, but that bubbled part is a thing to find out where is the problem. As it is large (wide) print it can show problematic areas. So if you have similar issues with prints in same area it could be something related to bed warping. but hard to say yet. need to do more prints
thought it might be easier if i comment here. just to be clear: you said supports are not needed. the 3mf file has supports enabled for all of the pieces. i am just trying to understand if it needs supports or not as the 3mf file has supports enabled.
View one more comment
@Warlogh_1253543 I am trying to make sure i understand. these are your settings. supports are being generated even though "only critical" is selected
@AmaliaCowan_310030 ah yes, now i remember. This is why I did left supports on. there are very little bit of them on pegs. Personally I did turn them off and print was ok without them, but not all printers perform very good on angles like here. in your case as you are not very confident, which is absolutely normal, leave them on. no harm here at all. It is good that You are trying to understand things. That will make you better and better in 3D printing. I have lots of things to learn as well.
Tried a few other designs, but couldn't find the perfect fit until this one. Turned out great on the first print, and fits snugly into the HSW.
Thanks!
PLA
0.2mm
0.4mm nozzle
@Bebbssos_459108 thanks for sharing. nice colour scheme
I printed the Holder for Bare Wall, and it worked great. Keep up the great work.
Thanks for sharing the model.
Thank You
@HAMMER_T thanks. Nice. That's good to know as I dod print for my needs one which was for P1S and it totally didn't work for X1C as X1C have very short cable other side
Hello, I tried printing this to test drive it. However, I have some issues with the fitting. Any suggested settings for FDM printer (I have a Ender-3 S1 Pro). I have used pretty much the defaults 0.2mm layer with 0.4mm nozzle settings of PrusaSlicer.
Issues:
1- Unable to push the bracket into the paint holder. The tab breaks and no matter how hard I push, the circle does not clip into the paint holder.
2- Unable to push the bracket into their slot.
@RedBeardManif very cool looking ones . Thanks for sharing
Easy print, used with double-sided tape to do the corners on a new table. Now I just need a holder for the collection!
@ConradRoberts_394815 thanks 4 sharing ;)
Hi,
Do you have imperial variants of these?
Thanks.
@TimX24968B_1991447 And again, sorry for late response. I have added Imperial variants as well