Warhorse Studios 5
Warhorse Studios
@WarhorseStudios
published a new model February 13, 2023 at 11:09 AM
February 13, 2023 at 11:09 AM

Ctrl + Enter to send Enter to add a new line
Warhorse Studios 5
Warhorse Studios
@WarhorseStudios
published a new model December 14, 2022 at 1:33 PM
December 14, 2022 at 1:33 PM

It is extremely nice gesture to the fans from Warhorse to release this model for print! As is usual, other, larger, international studios have something to learn from...
I like it so much, that I had to print not one, but two Henrys in succession, both in variable layer mode (mostly 0,07mm, 19h print body+shield), laid back and with custom 0,4mm wide "fins" to give additional support to the lowest points.
The silver PLA one wasn't that nice on the back side, also the sword's blade came off and one of the elbows got messed up (i had to re-print these as separate parts and glue on.)
The black/bronze one is ASA and came out almost perfect - it could have been in the acetone a little longer, but i feared that i would start to loose details.
I used a regular bronze spray from a hobbymarket, came out good enough.
The model could use splitting into even more parts, at least at the waist and the sword hand at the gauntlet, that would make it much more printable and that's why I only gave four stars.

0.25 nozzle at 0.05 layer height, scaled down a lot. Aside from stringing I need to work out looks pretty good for the size.

Ctrl + Enter to send Enter to add a new line
All items loaded