Hey, which connector did you use? Looks like Phoenix contact, but which exactly?
Verris, can go give some detail as to what looks like smaller XLR connectors your using between the gantry and the stealthburner? This seems like a must have mod to me. Also, if you could upload cad (.step/.stp) file, I'd like to make some mods (edited)
Perfect fit for two of the non-stacking mirror covers, so I imagine it would probably do even better with the nested ones it was designed for. Basically a must-have accessory as far as I'm concerned.
Cleaning up the print can be a little tricky given how tight tolerances can be, so if you've got any desire to clean out fine stringing you'll probably need to quickly run a heat gun/torch over the top to melt the stuff away. Screw holes also have fairly tight tolerances. On the plus side this looks great when it's installed, but the downside is that if the screw has any difficulty getting through the wood it'll walk the print up the threads. If you want to make sure you don't accidentally snap the thing in half with this, pilot holes are definitely recommended.
@JJReinem Thanks! The hole measurements were for some random screws I had on hand and I didn't have that problem, but drilling the pilot holes is definitely still a good idea.
Thanks a lot for this model — simple idea, very useful. A real must-have! (edited)
Much improved over original, stacks nicely and easier to twist on/off with the wider and longer handle tab thingy
