Perfect tolerances!
Do you remember what you set your steps to? Do you have a picture of your build?
@kenzo42_103425 I have aftermarket 3to1 gearbox nema motor as well so i don't think my steps numbers will help you. just too regular calibration with filament to figure out steps and use octoprint or something to upload new steps
Do I understand correctly that nema17 D-Shaft is going trough one lgx gear center instead of needle beering?
@Kowy_295784 yes ur correct!
Printed well however when I installed this and did the bed mesh level it crashes on the corner where the heatbed connection is
