Thank you so much for sharing the model. I need to figure out how to change it because my patches are on the outside of the tape. However, the model keep the tapes from unwinding, so I am happy so far.
@Honex_440409 Yes, I did not think about which side the patches are, it works fine with the patches on the inside. I have now 20mm patches from Eemann, they are on the outside too, so the same problem here...
@Honex_440409 Made modifications to the larger dispenser. It should now be able to handle patches on either side of the backing tape. The lid and the separators are the same as before so no need to reprint them. Added a slot just as you did in your print.
Hi, Thank you for the new version; it works very well. I also added a slot to the lid to see how much tape is left.
