Compared to many of the other designs for pixel watch stands, this is a lot more convenient to use, if you have the pixel stand, and doesn't put cables in the way of everything.

Not the most stable design - I printed it once out of PETG but wasn't convinced about its strength, so make it again out of Prusament PC blend (Urban Grey). I also needed to add a negative volume to enlarge the attachment hole at the base (by about 0.3 mm in diameter), as it was impossible to add the arm otherwise.

I'm pretty happy with the outcome so far - for me, this is probably the best pixel watch stand solution out there so far.

This stand is probably the simplest way to do it, and I really like it. The arm dows have some flex to it and when you put the charger in the base, and then the watch on it, there is some definite flex to the piece. Overall, it serves the purpose well, but I worry that over time it may fall away from the charger.