Didn't work for me: Printed in PETG with 3 walls and 35% infill, it was still flexible enough to make contact with the base of the printer at the far end. Blink Mini cam was a VERY tight fit, while the two holes where the plate is attached to the bed-carrier needed some hard pushing to fit making as the were a mm or two too far apart.
Geeetech PETG
3 walls
35% infill
normal speed
with supports (base-plate)
Didn't work for me: Printed in PETG with 3 walls and 35% infill, it was still flexible enough to make contact with the base of the printer at the far end. Blink Mini cam was a VERY tight fit, while the two holes where the plate is attached to the bed-carrier needed some hard pushing to fit making as the were a mm or two too far apart.