Thanks a lot for the model, I love the minimalist "factory-like" look. Had to go looking for the cover in the original model, but it turned out very well. (edited)

Printed well with organic supports, thanks!

Worked great. It snapped in just fine on the utility box but I had to force it a bit on the waste bin - that's almost certainly an issue on my end though, not the model itself.

Nice Idea, they look good.

This is awesome. Keeps my chargers right where I want them.

Printed easily and fits great for the most part. If I could make three small tweaks, it would be these:

1. The channel for routing the cord around the back is a bit too snug. Don't want to damage the cord by forcing it in, which is what it would take for my charger.

2. The fit for the puck itself could be slightly more snug. I ended up using double-sided tape to hold it in.

3. Add a hole on the back to allow pushing the puck out if needed rather than having to pry it from the front. I only thought of it after printing and ended up drilling a 1/4" hole in mine before assembly, but this would be trivial to incorporate into the design.

Since it's working fine for me as-is and I don't need another, I've got no need to make these changes myself, but they'd make a great revision for the creator. Thanks for sharing this!