Had to cut the box and the panel as it did not fit the mini. But worked out ok after some glueing and sanding. I like the design to make it portable. Printed in pla, the box in DasFilament BluePearl PLA, the rest in all sorts of pla.
@momin_1308224 I used a small burr on a Dremel to clean out some of the holes that were too tight; I was trying for a bit of a snug fit so the pegs wouldn't fall or bounce out too easily. How did printing at 102% work out?
Had to cut the box and the panel as it did not fit the mini. But worked out ok after some glueing and sanding. I like the design to make it portable.
Printed in pla, the box in DasFilament BluePearl PLA, the rest in all sorts of pla.
good but pieces are a little tight I'll print board at %102 and see what happens
@momin_1308224 I used a small burr on a Dremel to clean out some of the holes that were too tight; I was trying for a bit of a snug fit so the pegs wouldn't fall or bounce out too easily. How did printing at 102% work out?
@TbyD_27522 worked well fits loosely