hello, increase the height of the printer? Thank you
@Taso_258096
I would think it will add about 10-15mm but I do not have the original feet any longer so I am not sure. The height increase looks to be minimal.
Super easy to install thanks to the slot, and surprisingly effective at removing noise (using double yellow dot balls). The noise levels now are basically the same as when holding the printer in the air while printing. Adds about 10mm of height compared to original feet.
Printed in PETG, 0.20mm QUALITY (0.4mm nozzle), no supports. For mounting, I used one printed T-nut ( https://www.printables.com/model/66533-t-nut-for-prusa-i3-m3-m4-m5) and one M5x12 per foot. (edited)
@firetech Glad it worked for you, I have had at least one question on height, so thanks for add that it only adds about 10mm, that is very helpful. :)
printed in PETG
@MarkLivingst_1556939
Very nice, glad they worked for you!
You are a very brave man to do them in white 😀 (edited)
I was about to start printing these en masse, but I noticed on the test run that the female dove tails are offset slightly. I measured it in Prusa Slicer and on the one side its 6.250mm and 5.750mm from outer corner to the dovetail, respectively. However the male dovetails are 6.0mm on both sides of the same measurement. Is there a reason for the offset? I've attached a photo with screen shots from the slicer measurements (edited)
Haha, all good :), I didn't notice it until I assembled them. But yea if you want to upload the step I could make a remix. I was going to scale them up a bit too for a slightly tighter fit for my particular sockets :)
@DougWalker_1505534 Got them uploaded, good luck!