Printed with PETG, fits perfect!
Let's see how valuable it proofs in real life ;)
Printed with Prusament PLA at 0.20 Speed Preset settings without supports.
Nice design. It holds a 5 inch Quad on the Picture.
Would print again 👍
@Passforce is this 2,5 or 3,5 inch drone?
Works super well on my Australian Anko dehydrator. The filament cost for making all 4 sections of this smaller model is cheaper than making just 3 of the original files. You can see in one of the images the height difference, but even with my tallest spools, there is still about 1cm of clearance. I was going to make these changes myself so I am super happy they were already done by someone else, saved me a couple of minutes :)
Print with a brim or else you'll have a ton of failures.
Printed in PETG for extra heat resistance, love the print. If I had white or transparent it would look even better but only had black on hand. Uses around $5AUD of filament so this is a no-brainer. Thanks for the files!
