The Bahtinov mask helps a lot with finding the focus! Just a quick tip: when you're using it, place it in a way that the magnets do not engage, so it's easier to remove the mask without disturbing the telescope's position.

This printed great in PLA. It fits very nicely in the AMS. Smart design, and the hygrometer I ordered online fit perfectly.

What's the difference between circle-straight and circle-sideways?

Really like this design bud ! I wanted mine more snug so scaled to 201 mm on the x and y. Then filled it up with steel balls.

Great Job !

Works great! Thank you!

finally I succeeded, but very worrying, I had to remove the rear and side hull then once installed tighten everything....
Thank you for your work.

What did you use for remixing these? I wanted to do the same but wanted the lower lip. Thanks.

Screwless Filament Passthroughs to support my use of an Ikea container as a nearly-dry box. Nice design - looking forward to using them in assembly. Thanks!

I printed it and fits perfectly into the original AMS. Unfortunately the 13.5mm roller is missing which would be a perfect match for my spools (the biggest ones).

Print war easy and installation as well. Didn't had the chance to try it yet but I'm sure it will do a great job.

PolyLite Hex Rim.stl pins do not fit the PolyLite spools

Nice and sturdy. Prints well. Seems very strong with 25% gyroid infill.

Any idea why the bracket in the slicer says it needs to "repair unmanifold edges"? I'm running it, but never experienced that before, know why?

can i use the 3ft strand of lights on Amazon thats made by the same seller and brand

Hello, are you connecting both the new leds and the stock one to the GH 1.25 5v port?
If so, measure the amp draw, it shouldn't be over 0.3a