I printed the desk/shelf stand in Hatchbox 'transparent black' with gyroid infill for the fun pattern. I made two small changes. I increased the width by about 30% for more support to the jewel case. I also made the bottom plate thinner so the back more easily fits under albums/books behind it. The ledge prints with no support but gets a bit droopy, especially since I made it wider, so I supported it. I blocked about 20% of the area at the bend to make the supports easier to remove. Great item! I've printed 6 of them so far!
@snowcat22_986769 Hi, thanks for checking out my stand. I'd recommend printing it lying on the left or the right side, then you don't need any supports at all.
I printed the desk/shelf stand in Hatchbox 'transparent black' with gyroid infill for the fun pattern. I made two small changes. I increased the width by about 30% for more support to the jewel case. I also made the bottom plate thinner so the back more easily fits under albums/books behind it. The ledge prints with no support but gets a bit droopy, especially since I made it wider, so I supported it. I blocked about 20% of the area at the bend to make the supports easier to remove. Great item! I've printed 6 of them so far!
@snowcat22_986769
Hi, thanks for checking out my stand. I'd recommend printing it lying on the left or the right side, then you don't need any supports at all.