Converted my PolyDryer boxes to use PTFE fittings and tubing and was just putting some tape over the fitting when using the dryer. This print is super handy and works great for my use case! So simple I love it.
That one I buy as a complete set here https://s.click.aliexpress.com/e/_DDqPD3f
Nice! I just saved a 2011 iMac from the recycling depot and was looking to do this upgrade. I read that the fan control isn't even needed if you take out the optical drive so I'm looking forward to printing this!
@ECMinh_1905375 I'm glad you like it! You should also check out the OpenCore Legacy Patcher. I just successfully installed Sonoma, and it's working flawlessly.
Thank you, I just printed this and it turned out great. Do you have an equivalent Amazon link for the threaded inserts?
@chewiesells_2715368 I think this one should work.
[ J&J Products, Inc ] 6-32 Brass Insert 100pcs, 0.219 in OD, 0.15 in Length, Female 6-32 Thread, Press Fitting or Injection Molding Type, 100 pcs https://a.co/d/962Nfh8
@SimplyMaker_879791 Excellent, I ordered the exact one and it worked like a charm. Thanks!
Works wonderfully, the case did snap fit and no screws were required. The fit is also very good, leaving very little empty space inside.
Easy but super usefull print to play around with my nspanel on my desk. Didn’t bother with the cabling and just fed a cable through it
Perfect. I added the little foam protector that was in the box with double sided tape at the bottom (as suggested in the video). I screwed the power plug thing to the outside instead of the inside. That felt more secure when plugging in the cable.
