Came out pretty nice, unfortunately it doesn't fit. Used "sroub-g5-8-plny-v2" for this print. It only turnes in by a half turn, then it stucks. Didn't wated to force it in.
@FS_1254955 Hi, I'm sorry that the model doesn't fit as it should. I just want to ask if you changed the layer height for the thread to 0.12mm?
@Sendvic_22_1270829 I didn‘t, but this shouldn‘t have any impact on the threads. Maybe try it again and give you feedback
Came out pretty nice, unfortunately it doesn't fit. Used "sroub-g5-8-plny-v2" for this print. It only turnes in by a half turn, then it stucks. Didn't wated to force it in.
@FS_1254955 Hi, I'm sorry that the model doesn't fit as it should. I just want to ask if you changed the layer height for the thread to 0.12mm?
@Sendvic_22_1270829 I didn‘t, but this shouldn‘t have any impact on the threads. Maybe try it again and give you feedback