Standard Height dice tower.
Printed with PLA "marble" pattern filament.
I forgot to take a pre-assembly photo showing how I broke this down into all its constituent parts: Bottom part of tower, Top part of tower (sans turrets), crown of tower (turrets), 6x trap door mechanisms, 6 button tops, the 6x compression springs, compact tray, and modified clip.
You can see the clip was modified. The original clip held the tray so that it didn't move along the surface it sat on. However, it was flexible/ springy and a simple bump on either the tower or tray would open it up. Further, because it was so thin, if either the tower or tray bumped up off the surface, the clip would snap closed partially under the tray.
The clip modification makes it tougher, stiffer, and secures the tray to the tower both along the surface and vertically. It is much more resistant to a bump separating the two.
I'll upload the redesigned clip if I get a chance. (edited)
Can you upload a version that has all part of the box separate?
@Nuclearpotat_1248426 Hello :) Yes I can, and I will try to upload it later today. But just to be sure, if its for printing the parts, you can separate the parts in the slicer itself. I have attached a picture of where this can be done in the Prusa slicer :)