How did these work out for you? I had a very hard time getting the left one on due to the extra plate that covers the belt/motor. In the end, it ended up too low and crooked. The right side was fine.
I just got back in from the first use and I think I drilled the holes too low because it sits too high and leaving too much snow on the ground. Ideally, scraper should only be lifted 1/8". I may edit the file or re-drill the holes.
Also I think I might print out of TPU. The left one stayed on but after a couple hard hits of uneven sidewalk, the right one sheared off. I had sold bottom and really high infill, but that didn't seem to matter even with PETG.
Either way, thanks for the design!
View 2 more comments
@beyondthegrave_95235 haha, of course! :)
Sadly they were a bit of a failure. Partly since the front of my snow blower has some wear/dents on the metal. And then a failure since I only had a cheap petg at the time and they snapped off. I think the PETG is more brittle when cold. I think if i was to tackle this again it would need to be something like nylon when it can handle a bit more abuse.
Dang, I printed these but the one side will need heavy modification in order to actually attach it. I was hoping to see good results from everyone before drilling into my blower
I am working on version of this for the 13th gen (2023) tablet. Hopefully I will have it uploaded in maybe a week or two. I would like to make a few test prints before I post it.
@RonanWarrior_126637
Great! Just started printing. I will report here on the result. Thank you very much!
Just added models for the 13th Gen Fire 10 tablet. I am still testing the small printer three part versions, but hopefully I will have those posted later this week.
@RonanWarrior_126637 This design seems great. Any luck with the small printer version of the 13th Gen Fire 10?
@RobRodi_571728 Sorry i got distracted by things. I basically forgot to even make the files...let alone test them. I am not going to have time to work on this until the weekend when I have free time.