ReneFNX 12
ReneFNX
@ReneFNX_295899
published a new model August 27, 2024 at 8:04 AM
August 27, 2024 at 8:04 AM

Edit:
It works for printing in normal mode (0,2 mm) with PLA, but little more pressure deformed it.
Maybe this model is stronger with PETG filament, but i wasn't able to check it. (edited)

View 2 more comments

@Vortex_2258391 Hmm, I've never actually tried PLA, I mostly print with PETG. I guess it never broke because PETG is more flexible than PLA. Maybe the problem is that your filament became brittle because it absorbed too much moisture from the air.

@ReneFNX_295899 Filament was brand new (opened 1 day ago).
However after your messages i tried to print it again on other filament on 2 modes: normal (0,2 mm) and draft (0,28 mm). Draft mode print had still same issue like on a photo, but normal mode was a little bit stronger and was able to "hold" filament end. But little more pressure banded it also. Maybe this model is good for PETG but for PLA walls are bit too thin?

Ctrl + Enter to send Enter to add a new line
ReneFNX 12
ReneFNX
@ReneFNX_295899
published a new model May 3, 2023 at 7:05 AM
May 3, 2023 at 7:05 AM

Ctrl + Enter to send Enter to add a new line
ReneFNX 12
ReneFNX
@ReneFNX_295899
published a new model May 3, 2023 at 6:34 AM
May 3, 2023 at 6:34 AM

Ctrl + Enter to send Enter to add a new line
ReneFNX 12
ReneFNX
@ReneFNX_295899
published a new model May 3, 2023 at 6:32 AM
May 3, 2023 at 6:32 AM

Great 3D print! Great model, easy to print (no support structures). Very well designed. Looks great.

Ctrl + Enter to send Enter to add a new line
ReneFNX 12
ReneFNX
@ReneFNX_295899
published a new model April 28, 2023 at 6:43 AM
April 28, 2023 at 6:43 AM

Works better than expected. I printed it with PETG. Nozzle size: 0.4 mm Layer height: 0.1mm

Works better then expected, quite usefull. Printed it in PLA with 0.1mm Layer height

Ctrl + Enter to send Enter to add a new line
ReneFNX 12
ReneFNX
@ReneFNX_295899
published a new model April 27, 2023 at 11:53 AM
April 27, 2023 at 11:53 AM

It is a little too flimsy, and could do with a little ridge at the front, but it is nice and simple design.

Simple and efficient. Thanks

Ctrl + Enter to send Enter to add a new line
All items loaded