Works on the Prusa MINI horizontal rods. A version for the 10 mm vertical (smooth) rods would also be helpful!
Works on the Prusa MINI horizontal rods. A version for the 10 mm vertical (smooth) rods would also be helpful!
I may try printing this later for the smooth rods, but aren't you supposed to keep the vertical screw rods lubricant free? help.prusa3d.com/article/regular-printer-maintenance-mk4_419000 (edited)
@OldKingHamlet
Use superlube oil 51010(or 51014 same but under blister) for smooth rods. (PTFE OIL, same as 21030 but oil)
data-sheet 51010 : https://www.super-lube.com/Content/Images/uploaded/documents/TDS/Technical_Data_Sheet_Multi_Use_Oil_w_Syncolon.pdf
This part and 21030 Grease is for vertical(or horiz.) screw rods also for other brand (like bambu, ender,...)
I've 3 MK3, 1 MK4, 1 Mini, 1 XL and 1 Bambu X1C, Some of them, which have been mentioned for years, are maintained with this grease and oil. vertical and horizontal screw shafts or smooth. Clean well beforehand with a cloth and, for example, the tool I mentioned for the screw rods. (edited)
Printed nicely without supports, but I did use brims. They fit well and I was able to replace all 8 of the broken originals and restore my whatever brand of photo light box. Thanks for the design! (edited)
@JC_1494448 Well done ! Thanks for the report and pictures.
Soldering XLR connectors used to be such a pain. But with this handy little tool its made really easy and convenient.
I printed it with PETG on my A1 mini. It worked without any problems, but I think if I had printed it on my Raise Pro 2 the text at the bottom would have caused problems with the first layer.
@HeMue253_1330257 thanks for the report and picture ;)
Lovely easy print. Thanks for sharing. The holes might be a little to thin. But on the other side the connectors fits perfectly.Printed with PLA on X1C
@IngoImmer_1410824 Nice print thanks for the report and picture ;)
Printed it in pla at .2 layer height without supports, turned out great
@TurtleMonkey8_477280 Very nice print ! thanks for the report and picture
@DerW_940864 Thanks for the report and picture ;)
i like to do my part i found an company that sells silicon sleeves and ordered 2 sleeves with different sizes to test i got the bearings and the printed parts i will print with resin abs
ive used this since Jan 2024 and the silicon band finally came off this would be really great if i can find a silicone tube that would squeese over the bearing without a seem i think it would last forever very hard to get silicon strips glued i also used real springs
had a bunch i bought on amazon worked really well andit just finnaly came off after i beat it up if i can find a tube that i can cut and make fit ill post it here