Creality " let the customers build a working printer" Pure lol. I like your design Radu :)
@DanKilmer_330202 thank you!
@DanKilmer_330202 too late mine are in in black but your comment has made me super paranoid to check at least 🤣
Do yourself a favor and DO NOT print this in black. I came very close to starting a print with these still attached lol.
@LeeChatten_360802 That crossed my mind leaving these in. Mine are bright orange though
one issue here, we all use different settings on our slicers. to use your design, it is vital to get to the exact same configurations as to have the exact same weight in the design. We are talking about milligram's that is making a difference here. if the weight of designs are not accurately the same, then one cannot assume it will be 110Hz.
Yes the model can however be used for comparison between the two sides, but not for desired tension.
Could you perhaps share your gcode file of K1 printer???. Then one can just load and print as to get the exact same weight of print
For those of you trying to get the weight down to 1.94. I was able to do it by adding the following settings to Orca:
- Enable "Small area flow compensation"
- elephant foot compensation 0.2
- Monotonic top/bottom
- top/bottom/wall overlap: 10%
- Apply gap fill: everywhere
- Filter out tiny gaps: 10mm
- Infill/wall overlap: 10
Hope this helps (edited)
Solved an annoying problem. Old cover broke figured this one at least had some function. Fit great
very cool!!!! im going to make this now!
perfect, thx :)