Racknos
@Racknos
Works great, thanks for the model! Even though I used only 50% infill (PLA) for the base because I was in a hurry 😅 I still used 100% for the top.
I would love this model for 3.5" Hard Drives if possible.
Would not recommend. It holds the hard drives wayyy to hard. It also uses too much material.
needed something taller for my online proctored exams so I extended the legs quite a bit and it’s still reasonably sturdy. Had to reprint the part with the screw and scale it up 1% to be a tighter fit to my webcam but all other parts still fit. Upped the infill on the legs to 35% after I extended them to make them a little more rigid and printed them with a brim but honestly I don’t think that was needed. (edited)
