The promo photo for Prusament PP Carbon Fiber.

Super Print. 50% . 0.15

Krásný jednoduchý tisk a výborný výsledek-díky.

Printed with Prusament Resin Tough Prusa Orange. I love the detail the artist put into this model. (edited)

Worked ok with FDM. Had a couple little pieces break during support removal.

I'd never printed anything with PVB before and had some samples I wanted to try. This printed very nicely and looks great. I may try printing it with a larger nozzle to see if it would be a little stiffer. Printed on a Prusa MK4S with Prusament Dark Blue Transparent PVB. Thanks for the model! --Harry

Elegoo Marble PLA on carbon print bed

Tried this vase in miniature version to be able to print it with the rest of my filament approx. 10g :)

Prusament Terracotta PETG

Top

Thanks for sharing. Fits ports perfectly once pi is seated properly.

i had no problems printing pla so no petg np

It doesn't roll on my MMU spool holders. Do I need to change the print settings?

Guys, I don't think this is AMS compatible.

Does this require the hexagonal filament?

Hello Prusament Team,
I love hexagons too. I couldn’t wait until my order arrives, so I used my craft knife and prepared a 55m string of filament to be able to print perfect hexagons today. The result speaks for itself, even with the handcrafted filament it’s more hexagonal. My Prusa MK3 sounds more happy with it too. Can’t wait to reprint with original high hexagonality Prusament PLA Gravity Grey Hex.
Thanks for your great idea! It was a nice challenge to get it printed on same day (April 1st), but I managed it and had fun printing hexagonal modern art!
Best regards,
Klaus

Made with overture PETG on Ender 3.

Printed some of these clamps for my little sister for her forts. Perfect clamps.

Printed in PC-CF. The fact that you have to print the screw vertically makes it very prone to layer separation when loaded. So in the end this is just a toy. A very nice looking one though. (edited)

Printed great with Prusament PETG Recycled

Thank you for the model. Printed on Prusa MK4S PETG Prusament orange so I can use the spool for refill

Printed with some Prusament PETG I had leftover and it looks good. Works as it should, when tightening the refill together, some parts were very hard to fit together, but that was not the tighteners fault.

Thanks for the model. I haven't had a chance to use it yet, but I will soon. I have a few refills that I got from Prusa with my last order. As usual, I should have ordered more.

Printed from PLA. Precise design. Thanks

Prusa XL
PLA
0.6 nozzle
0.25 layers
15h 34m