~*THE ULTIMATE*~ Tanto Blade Styled Combat Knife/Short Sword *Self Defense Model* - Fully Printable*
I really did not expect this one to come out as nice as it did for me. That gcode is absolutely perfect man (edited)
Printed using gcode with PETG came out awesome very sharp and can indeed be used fot self defence if needed
NSFW
Then you find out its some 89 year old man critically ill with cancer... that has to go get groceries to survive... yet you still feel great that you got yours.... dude the world does not revolve around you brother. Design something positive.
View 9 more comments
@NightRaid You properbly right mate!! I better start watching my back xD
@MathiasHedega_679186 dude's been hunting me down too trying too, shame our friend didn't post his address so I could send him a package of these to stick on his own vehicle to save others the time.
this is amazing!
I reprinted this in a dark purple silk. It took 37 hours. I like to print silk. Very slow. I used custom supports in cura. But honestly looking at when it was done. The supports were barely holding them to anything. perhaps you can print this without any support at all. Anyhow, it's the way she goes for now! (edited)
@Itsjustricha_1403376 I loveeee the purple man super cool, and after I made this I realized that I should've designed the center piece under the dragon a little thicker because when I did a 100% infill print my top weighed it down so much that with a solid bed adhesion my second one accidently snapped on me at that point lol so instead of wasting anyone else's time I decided to throw organics on there so nobody would meet the same fate I did
my longest single print up to now with araoud 28h ;D
0,15mm layer came out with really nice details!!!
Printed in awesome PLA : AMOLEN 3D Drucker Filament Tri Color Silk PLA Filament - Farbe: dreifach blau grün orange
@pr3mium_3D right on :D came out looking sweeeet!
This prints well and is a very good knife functionally. If I knew how to rate it would get 5 stars easy.
i am an absolute noob but i’ve been tinkering with the design for about a week and i really liked my first print of it but wanted to take it to school so i did this…
@Amil_746526 haha this is so cool love it!
Just a recommendation, I wonder if you could angle the finger grip section a bit, it’s a little impractical to hold, compared to a classic knuckle duster, where the grip contours with the hand. You can see in the picture the outside finger grips are spread to high.
@thechrisalan_148246 yeah it is, its because of the ability to go ambidextrous with it, I used 20 hands as models to base this one off of. It's still a work in progress but I
will specifically fine tune that point thoroughly, thank you for the helpful input.
Protect your self or just show off with that cosplay costume ;) and for that first option, this tool does the job a little bit too good... be sure to be carful when playing with this movie prop! (edited)