do you have a picture of a car with this installed? curious how you designed this to fit! printing it now and getting my furitek in a few days. having a hard time picturing how it goes.
@TrevorConawa_1144155 yes, i uploaded 3 pics, i only used the rear screws and the front rests on the motor
My supports were awful for this one, way too big a PITA to remove. I also feel like instead of simply adding the lip for stacking on the bottom, the bottom of the crate should be lowered to the plate since that was absolutely too much time/filament/time to print supports under that and then remove them O_OOther thoughts for improvement- fillet the horizontal overhangs, I had a lot of droopy bits which could be my fault as im figuring out my printer
