Muth 11
Muth
@Muth
published a new model January 22, 2024 at 3:34 PM
January 22, 2024 at 3:34 PM

job printed but I have an stupid question... in which direction I need to install the fan? throwing air to the bulb or extracting it?

View one more comment

@Muth i did it in PLA. It’s almost done. I must to print the smoke. In the picture you can see my issue with the wing, but the design is incredible. Goood, goood job!!

@EduuardJuan_627652 Oh I see, it looks like the wing is not going deep into the leg groove. Maybe try sending a chamfer as highlighted in the following pictures. But for me too, the join isn't perfect. I suspect because of the steel sheet bending due to wrapping.

Ctrl + Enter to send Enter to add a new line
Muth 11
Muth
@Muth
published a new model May 1, 2023 at 1:55 PM
May 1, 2023 at 1:55 PM

Awesome! I love it! 2000% scale, 130cm tall.For the flame i had different approach. I had printed the flame with transparent petg but the diamonds with white pla. I embedded single led lights to each diamond making a hole to the top of each diamond to place a 3v led and another smaller hole to the bottom of the diamonds to pass thin cables that connects in series all the 4 leds starting from the bottom and upwards. Unfortunately for this procedure i didn't took pictures. So i didn't used a GU type lamp. Also the plume is lighting with 12v led strips.

View one more comment

@evoxslaydiy_2060885 Looks awesome! May I ask which PLA Colors you used? Thank you!

Not perfect, but super cool. Modified the lamp part and plume a bit from original.

@APN201_2601391 Nice ! I managed to improve the wing-foot assembly by sanding a bit the lower/wider par of the wind to create a kind of chamfer.
Thanks for the picture !

Ctrl + Enter to send Enter to add a new line
Muth 11
Muth
@Muth
published a new model October 26, 2022 at 4:28 PM
October 26, 2022 at 4:28 PM

Great print! The clearances for the board and the screws are a little tight, but I love the design and it works very well! Printed on a Markforged Mark 2 in Onyx filament. (edited)

Ctrl + Enter to send Enter to add a new line
All items loaded