Ein Bilderbuchfall für Non-Planar Slicing, schätze ich! :-)
https://3druck.com/programme/neuer-open-source-slicer-ermoeglicht-nicht-planaren-3d-druck-09146352/
@BikeCyclist Ui! Absolut!
Hi, but this lens cover is only good if you keep the silicone protection around the lens, without the silicone frame the lens protection is too large and therefore unusable.
View one more comment
Dosent fit ace pro 2 with silicone ring. I couldn't get it to fit properly would always push ring down. Printed with petg
@Bubba_476263 Thanks for the feedback. well, Printer tolerances can vary. But yes, the ring is a bit annoying, but I can still use the cap well. The rubber ring on the camera slips off really quickly. Maybe it would be better to remove it in the first place ;)
Hi! I have also a Pavo 20 drone and printed you model to replace the crash damaged ducts. Just a question. Have you added brass inserts to hold the screws, or the TPU on its own is enough?
@Grizzlychan_2442726 Hei!
I screwd directly in the TPU print. It holds for me without any problems. The screws should be long enough. I've already done many flights with it and I have to say that I'm really happy with it. Crashes haven't been a problem so far.
Ill be happy if you show the print later ;) (edited)
Hi! I made out of transparent TPU and feels more durable than the one which is based on. Or at least less likely to disintegrate, which is part of the fpv hobby. :)
@Grizzlychan_2442726 looks great!
