Appears to work great. I had to remix the enclosure mount due to the heated add-on I have on my drybox. I'll post the remix very soon.
Glad it works for you! Thanks for the comment!
@MikeB_1505898 No problem. Thank you for taking the time to sign and share this!
Just made mine! It's fantastic and was very easy to put together. I believe I want to modify the vertical arched pieces that go in front of the rollers to be slightly shorter at the bottom because if I make the pieces flush with the top of the shuffler it appears there may not be enough space for the cards to go through.
If I move it up by like 3-4mm it seems to do the trick.
It may be possible I assembled it wrong, but yeah. Love the remix!
@DougJohnson_3429036 I've been using mine intentionally with the top not level - the intent I think is to always keep adjusting the height of those vertical "blockers" depending on the thickness of the cards.
Glad it works well for you! Nice looking print too...
This turned out awesome! Thank you for uploading your remix, it is going to be a great Christmas Gift.
Just a few suggestions if you feel like working on it more:
The base is a bit too tall for single sleeved decks, there was just enough room for a few cards to flip once in a while. I cut out 25mm from the center and that seemed to work pretty well.
The clips for the base have room to be thicker and taller. I had a couple break trying to get them over the top of the foot which was pretty tight.
The last thing would be to size up the rubber band shaft remix to fit as well.
Thank you again
View 2 more comments
@Drakorex Thanks for the make! It didn't show up for me until the next day (probably needed to refresh the browser).
I've uploaded the modified base (slightly higher and thicker latches), as well as a half-height base. I also scaled up the rubber band shaft model. None of these have been test-printed though.
@MikeB_1505898 Awesome, I will probably give it a shot in a week if I get time.
Thank you! I see you have a different model of multimeter - did you resize the model to fit? (edited)
@MikeB_1505898 No. I cut the "step" using the PrusaSlicer modifier
Awesome! This is perfect, I have a few high viscosity products that this will be amazing for! Thank you for making this!
@QuinnEnestve_2120324 If you need a different size, feel free to ask... I uploaded my 2nd type and specified the dimensions.
