Micah | Printables.com

FIRST Tech Challenge (FTC) Control System Module

published a new model February 22 at 4:42 AM

February 22 at 4:42 AM

0

6

FIRST Tech Challenge (FTC) Robot Battery Charging Station

published a new model February 17 at 6:04 PM

February 17 at 6:04 PM

1

0

3

FIRST Tech Challenge (FTC) Power Switch Label

published a new model January 26 at 4:28 PM

January 26 at 4:28 PM

1

0

3

Spool Rim Compatible with Creality CFS

published a new model November 13, 2024 at 8:22 PM

November 13, 2024 at 8:22 PM

70

4.4

633

22

Simon

@Simon_987357

Thanks for this design.
These are perfect, and fit really well. They only take about 12 minutes each to print on my K1 in Creality Hyper PLA.
Now the only thing I need to remember is not to have them on rolls of filament that I put in my dryer as they are only printed in PLA 😀

10

Pablo Vallejo De Hoyos

@PabloVallejoD_300809

Improved goBILDA/Matrix/Modern Robotics "Brick" Battery Holder for FTC

published a new model August 25, 2024 at 9:40 PM

August 25, 2024 at 9:40 PM

3

0

109

M 1

MLloops25

@MLloops25_2443934

The hex holes and velcro straps are excellent and were perfect fits to the GoBilda channel. I think you need to add about 1-2mm to the radius of the walls, as I wasn't able to get any of my matrix batteries to fix

@MLloops25_2443934 yeah, I finally got around to trying it and the walls are too tight. So, I need to push them out a bit. I'd rather have batteries fit a little loose since they aren't made with tight tolerances, batteries might swell, etc. I'll get an update out soon.