Works as intended. Great job

Amazing print. Wish the stand is angle at certain angle for best viewing. But it should be easy to fix it.

I think I like your design more than mine! :-)

great model easy to print and works well thanks (just got to add the adjustable chuck to finish it)

Pro mezeru okolo 6mm max

Pretty Cool, Just what I needed !

Funguje pouze do mezery zhruba 7mm

I haven't optimized for TPU print so it was
stringing like crazy, but it still works.

Can I please have the assembly instructions?

Works Great

perfect

This is great! I use this for filament scraps. Thank you!

I did not mention that it will not fit on regular folding rulers. It was my own fault. It would be great if you could make another version for folding rulers (3,5x16,5mm?!). The thread runs very smooth. Thank you

Aun no lo probé, pero el archivo no tenia los agujeros para las bridas, y como otro compañero yo también se lo añadí. Lo imprimí en PETG.

Polaroid PLA GLOW 0.3mm 100% infill (edited)

It needs a little more work to open and close well.

Excelente diseño fácil de imprimir

A little tight, had to sand the inner diameter just a little bit. Might have to tune my printer. Works fine and tidies up my printer area. Thanks!