Mark.coppola | Printables.com

published a new model September 18, 2023 at 5:32 PM

September 18, 2023 at 5:32 PM

Philips Hue Motion Detector Bracket

0

23

13

Mark.coppola

@Markcoppola_279471

published a new model December 26, 2022 at 3:32 PM

December 26, 2022 at 3:32 PM

GST-9 MOD1 Grip Handle

4

0

98

13

Mark.coppola

@Markcoppola_279471

published a new model October 21, 2022 at 2:51 PM

October 21, 2022 at 2:51 PM

P320 FCU Bending Kit (WORK IN PROGRESS)

21

0

344

13

Mark.coppola

@Markcoppola_279471

published a new model July 2, 2022 at 5:39 PM

July 2, 2022 at 5:39 PM

Milwaukee Packout Rail bracket

250

5

1,584

9

Richard Miller

@RichardMiller_86645

I went with a STEEL bar instead (I bought both), but it makes turning it into a magnetic bar much easier. ;-> Works great. Tolerance on the fit was very good. Some are too tight. This one worked well at 0.30

1

DRock3d

@DRock3d_354698

This doesn't fit 2" flat stock, the slot is 1 1/2". I scaled the Z up to 66mm for a clean fit of 2" stock since I already purchased the recommended material from the description. @Markcoppola_279471 you should adjust