Wow what a great looking PCB ! Black and gold is never wrong.
(also board looks expensive.....)
Working on a VTOL Drone - project will be open sourced by summer (assuming everything works)
This is the biggest electronics project ive done so far, and there hasn't been any magic smoke... yet...
PCB partially funded by PCBWay - Once again, great PCB quality, no complaints!
Looking Great!
Was excited to try this but the link to your V2 doesn't seem to load?
Added a second button to enable or disable the extra fans.
Very good case that just works and looks good.
View 2 more comments
@darkcruix_762218 Can you give a quick explanation for how you connected the power button to the board? It's not obvious to me.
@JohnBonomi_492656 There are two options, one is to buy a breakout board for the connector, which I didn't do.
The second option is to solder wires on each side on the tiny on board switch for the power. I used two small wires and connected them to the external power switch. To keep it stable, I also put solder mask on top of the wires and cured it with UV light. If I need to remove them, I can just remove the solder mask and then de-solder the wires.
Printed with PETG outer, PLA inner which prevented fusing and it worked great straight off the bed. I rotated the inner body 1.5deg, as well. My magnets were a bit larger than specified so I pressed them into a hole from the far side.
nice! looks like it came out well
1st print with 0.4n failed. Maybe I should have read the instructions 🙄. Came out perfect with 0.25n finally.
the sliding works quite well, though the tiny spacers tend to fall inside when opening the dryer.
Printed with XPETG matte.
Does this model have Vesa mounts?
I love your remix! I'm working on a remix of my own, and your model and step files were an amazing starting point. Thank you so much for sharing it!
View 2 more comments
@Magmabow Hey man! I finished my model. I published it here: https://www.printables.com/model/1055997-framework-mainboard-19-inch-rack-mount and added a big thanks to you there!
@Mauker nice - it looks great! (thank you too!)
Hi @Magmabow I like this version of your ratchet with bearing, I have already printed the newer print in place version. But I'd like to redo the 1. version to a different bearing and different type of bits. Could you send me the cad file (f3d or step) of the ratchet, I tried to click on the link in the description but it didn't work. (edited)
Steel part for a project coming soon O.o
(the file can also be printed with PETG when i release the project)
(Thank you to PCBWay for this one too)