Looks pretty awesome. I am willing to print that and put it on my Trident. Could you add a section in the Details where you describe the print orientation or where to use supports? I can’t figure out how some of the parts should be printed without using loads of support.
Thanks in advance
@ChristianH_2711442 The only part that needs support should be the EBB36Mount.stl. All the other parts should be printable without support if you orientate it using one of the flat faces. The cable cover might need you to use a brim for bed adhesion
How do you have your noctua fan wired to the EBB36 board?
@agellatly_135081 I've made Y-splitter cable for the 4010 fan, shares power with hotend fan as it is always active while printing.
@stormrage_2451904 I ended up doing the same!
@NoSleepForMe The backlash I set it to was 0.25mm by default. If you have a printer with very good tolerances this might be a bit too much. Mine isn't the most well calibrated in the world so...
I remixed it a bit to have 4 planet gears, thanks a lot for this design, I love it and the fact that it is parametric is very useful
Thanks for the quick fun print. Two color printing makes the lettering pop. Printed with PLA - 0.30mm draft & 20% grid infill (edited)
NSFW
He;s a little rough, but hey, who doesn't like their wine bottlecaps with some grit eh...
Def going to make a great gift. Thanks.
Printed fine, thanks.
For the roller I instead used the remix "Improved Spool holder with rims"
I'm thinking about making the SpoolHolderRod hollow so that it can hold desiccant beads inside, but I'm not sure how to do it. (edited)