Guten tag Lisa,
I am looking at printing this.. Zuerste - Danke fur Das Schaffen und zeit!!
is it possible to use the setting you mentioned - without a full-area base plate being printed on the bed? ie. can it just make a rim a few layers either side of the circle as support/base?
I am new to printing and not sure if this is necessary, or if I'm doing something wrong (edited)
@LisaE_183192 Danke sehr! Ich hab nur noch ein paar prints gemacht - warscheinlich meine fehler... ich kann es noch nie igengwo sehen in der berschreibung! many thanks from Australia!
@SamJames_2505941 I have changed the text, I hope it is clearer now. I hope your printing is successful and useful for you.
Best regards from Germany
Just FYI, for Paperwhite 5 (11 gen) it's too unstable. Just a little touch, turns it over.
