Děkuju za možnost stažení
A pen cup that's pre-tipped over (for my convenience!) Brilliant! :D
@Chmarr I didn't think about it that way.
I designed because I built a new desk with shelves, my old cups for my tools and brushes were to tall to put under the shelves, and shorter cups would just tip over, but I guess I didn't change anything. 🤣
Just what I was looking for so I can take a spare battery out with me while weed wacking. (edited)
Nice little chest, the recommended magnets fit perfectly, it's only a bit difficult to keep them in their holes. Using double sided tape did not work very well...:)
In the second photo I inserted another model which in whole should be a present.
The CandyHeartBox model is from here:
https://www.thingiverse.com/thing:205905
How do you attach the minis to the bases?
@Dragon_226655 You say your preferred method but dont give any examples and I am pretty sure my normal super glue method isnt ideal if I want to remove them to put on normal bases.
A nice way to connect PVB and PLA. I miss the tip on the stone and would have liked to have had the enlightenment sooner to print without infill.
Also it's fully resizable and could be printed without Supports.
I definitely print some more of these.
Easy to print, simple but functional design.