Hello I noticed in the build video you also printed the LEONI dress pack all the way to Joint 6 Bracket would you be able to share those files as well? This is quite an amazing project!
Prints great! But I got a slight layer shift. I think I need to recalibrate my printer
Have you been able to check the alignment of the burrs? I'd imagine it could be a problem if the prints aren't rigid enough.
@BenceSzentiv_2046992Hello. You can check it by fingers after assembling. I tried to make the parts tight enough. Thread holes are small enough and works like "centring pims. And the parts which touches in and out of bearings surface has to be pushed with the force.
Was really quite a project, but so much fun to build! I adjusted the electronics a little bit with a IBT 2 motor driver and 24v Supply/Motor. The the Stops inserted in the 3mf helped a lot.
Sadly my motor isn‘t strong enough to handle light rosted beans, so I have to buy a new one.
