@KostasZ_9678 Howdy, hopee your well. If you dont have time. would you be willing to share the Fusion or othere format raaw file, reming the STL for the canopy pegs as per my picturees isnt going too well.
@KostasZ_9678 Hopefully this helps- I am trying to A) reduce the overlap distance on the rear chassiss screw point - abnout 0.5 mm each side B) increase the width of the front chassis screw point - about 1mm each side c) add 'locating' pegs (basically a little circle ridge) that will slide inside canopy locating column pillar things - also adding strength.
Not sure if I have a newer canopy design or why its different butt this kit is about 4 montths old. (edited)
@KostasZ_9678 Howdy, hopee your well. If you dont have time. would you be willing to share the Fusion or othere format raaw file, reming the STL for the canopy pegs as per my picturees isnt going too well.
@DruiD_1343766 Ahh superstar!! Thx
@KostasZ_9678 Hopefully this helps- I am trying to
A) reduce the overlap distance on the rear chassiss screw point - abnout 0.5 mm each side
B) increase the width of the front chassis screw point - about 1mm each side
c) add 'locating' pegs (basically a little circle ridge) that will slide inside canopy locating column pillar things - also adding strength.
Not sure if I have a newer canopy design or why its different butt this kit is about 4 montths old. (edited)
So much nicer to load batteries. Well Done