3DQF PLA Signal Red
I have never understood why Milwaukee put so much dead space in the middle of their organizer and these models made me really happy that I would be able to use that space finally. These printed easily using Prusament Lipstick Red PLA. I had a little trouble fitting a half, 2 quarters, and the front in, they were REALLY tight and it was hard to remove one if I wanted to. Swapping out one of the quarters for a sixth left a tiny bit of extra room but made it easier to remove them if I needed. Thanks for the model! --Harry
Fantastic fit, works great so far! Thanks. Printed in Eryone PETG, 0.6mm nozzle.
Works great! Easy to print, fits nicely on MK4. The printer is now really quieter.
PLA, 0.6mm, 0.25mm STRUCTURAL IS. (Speed one did not work out)